Height: distance between the lowest point and the highest point of the crossbar Do not enter the same value more than once, in order not to cause the repetition of the crossbar The value of the height of the crossbar must be between zero and the value of the height of the handrail.Įnter the height of all the crossbar you want to insert into the handrail of the stair being built and click on the Addbutton. Height of the crossbar: the height of the handrail is displayed, and from this measure, it is possible to determine the height at which the crossbar will be inserted in the handrail in the Height of the crossbar property. TIP: the guiding lines can be used to align the stair with the neighbors of the item in the design Define the maximum spacing between pillars, which is the distance between the pillars that are inserted in the stair landing TIP: to deselect all points, click the Select Nonebutton Ģ. Select pairs: selects the two points of the step that is clicked Select all: select all the points of the steps Select one of the ways of inserting pillars: To insert handrail pillars on the stairs:ġ.
The pillars are inserted on the points located on the steps. Step 5: define points to insert handrail pillars Diameter: length of the straight line that passes through the center of the column.Width: distance from one side to the other of the pillar.Height: distance between the lowest point and the highest point of the pillar.Diameter: length of the straight line that passes through the center of the circular handrail.Width: distance on one side between the first pair of handrail crossbars.Height: distance between the lowest point and the highest point of the first rail of the handrail.Based on the height of the handrail, the pillar is created In the Heightproperty, define the height of the handrail structure, which is the distance from the beginning to the end of the column. IMPORTANT: if the built stair has no handrails, uncheck the Handrailsoption.ġ. Click the Forward button to perform the next step. Lateral spacing: distance between the beginning of the step and the beginning of the beam Ģ.If the beam is lateral, there will always be two beams IMPORTANT: the number of beams can only be configured in the type of beam is normal. If you choose only one beam, it is inserted in the center of the stairs. If you choose two beams, one is inserted on the left side and the other on the right side of the stairs. Quantity: number of beams to be inserted in the stairs.Normal: beams placed under the stairs, in order to support the steps. Width: distance from side to side of the beam.None: no type of beam is inserted into the stair To finish the construction of the stairs, click with the right mouse button Ĥ. Repeat the above step to building other flights of stairs ģ. Each click of the mouse corresponds to the creation of a flight of stairs Ģ. In the graphic area of the editor, click on the point where the stair will be built and move the mouse in the desired direction to form the flight of the stair. Click the Forward button to perform the next step.ġ. Overpass: overlapping distance of a step in relation to the lower step ģ.Thickness: measure the height of a step.Height: distance between one step and another.Width: distance from side to side of the step.The measure for the step of the steps is calculated automatically, starting from the extension of the stairs Height: distance from the floor to the last step.Step 1: define the stair type and its propertiesġ. Click on the Build Stairs button on the top toolbar, in the group of facilitators
0 kommentar(er)
